PROMOSOLV™ COAT UT10-UV is a transparent hydrophobic and oleophobic ultrathin coating to protect electronics and other surfaces against moisture, corrosion and other environmental conditions that could jeopardize the reliability of the device or surface.

PROMOSOLV™ COAT UT10-UV adheres well to a wide variety of material substrates as plastic, glass, metal and ceramic. This product is formulated by Inventec with a UV tracer for easy detection under UV light in order to support quality control.

Features:

• Provides exceptional repellence of all kinds of liquids
• Fast drying at room temperature (<1 min)
• UV tracer with wide detection spectrum for easy quality control
• Substantial cost reduction due to small amount of product needed and simplicity of process
• PCB masking is not required, saving on preparation time
• No CMR substances
• Low environmental impact & very low VOC
• Non-flammable.

Application:

The best process will depend on factors such as operating conditions, equipment, time and the cleanliness of the parts.

• Dipping process recommended/spray application possible (especially for selective deposition)
• Typical coating thickness is about 0.2 to 0.5 microns by dipping application
• Recommended to apply on cleaned and dried surfaces
• Touch dry within less than a minute / No thermal or UV cure required
• Visible under UV light (around 350nm) to allow inspection after the coating is applied. The UV tracer will disappear within 1-2 weeks after the coating is applied as it has no function in the protective properties of the coating
• In order to manage the solid content in the coating bath, PROMOSOLV™ COAT DILUENT 10 is used to add solvent and PROMOSOLV™ COAT UT10 8% (no UV tracer needed) is used to add solid content
• PROMOSOLV™ COAT DILUENT 10 can also be used to remove coating or for nozzle and equipment cleaning.

Packaging:

• 8 kg drum